Teacher
 •Â
25 Messages
Wednesday, August 21st, 2019 12:27 PM
Mcafee says computer at risk
I have the free version of Mcafee from att. It has worked fine. But then I updated it , now after the scans it says computer at risk. I hit the button that says fix and up pops a version you have to pay for.Â
Whats going on ? I thought ATT was giving the protection for free. anyone else having this problem
Questions
0
0
0
0
Responses
Related Conversations
Trending Accepted Solutions (30 days)
Accepted Solution
Official Solution
Raspberry Pi Webiopi Site Host - Cannot connect while on local address. Outside network works fine
Setup:Modem/Router - BGW210-700   - Port forwarding configured for port 8000 to redirect to Raspberry piRaspberry pi running WebIOPi   - connected via ethernet cable to port 1   - local IP address = 192.168.0.xxx   - Webserver host port = 8000   - Hosting a html page. Single page, that ha
Questions
4.5K
9
0
0
Accepted Solution
Official Solution
Att 1000 internet recommend gigabit router
Should I get a netgear nighthawk route to pair with the equipment AT&T is sending me in the mail so I can get the full 1000mbs  I’m paying for
Questions
683
2
0
0
Accepted Solution
Considering adding wired Unifi AP
Hello, I just got the AT&T Fiber Internet, with the ARRIS 210-700 Gateway, and it is fast when it is. The issue I'm having is that the Login page to the gateway becomes sluggish often, I have connected 15 devices, including IP cams, printers, portable devices, Amazon devices, NAS. Basically the sam
Questions
222
5
0
0
Accepted Solution
Official Solution
Troubleshooting slow AT&T fiber
AT&T Fiber - What you need for Speed  AT&T Fiber requires the right hardware. If your device(s) is not compatible with gigabit speeds, you may not be able to take advantage of the plan/ speed you purchased. Check out what you need below!  The right hardware  A network card that can support the p
Questions
29
74
0
Accepted Solution
Official Solution
Upgrade Firmware on Pace 5268AC
How can the firmware be upgrade on this device? Usually there is a way to download a file and upgrade a router but I haven't found a way yet with this device. Currently on 10.5.3.527171-att and I've seen posts listing firmware numbers higher than this. I'm hoping a bug on the auto-select wifi channe
Questions
18
13
0
0
Visit the Community How-To.
No Responses!